The use of agricultural sprayer

Hand Sprayer

1 To properly install the sprayer components. Check all connections for leaks, use water spray test before installation and then install agents.

(2) when the first official use of additional agents, add water, the liquid's surface can not exceed the safe water line. Pulling the joystick before spraying more than 10 times, so that the barrel pressure up to operating pressure. Not use excessive force when pulling the joystick to avoid the gas chamber explosion.

3. The initial loading of liquid, because the gas chamber and spray bar contains water, the spray initial 2 to 3 minutes, the injected liquid concentration is low, it should pay attention to fill plastic sprayer spray to avoid affecting the pest control effect.

4 After work should be poured barrel residual liquid, washed with water and pour dry, while checking the gas chamber without water, if water, to remove the water connector release water.

5 If you do not use the spray near term, the main components should be clean, dry bottles in a cool dry place. If the long-term need, all metal parts have to be buttered, to prevent rust.

Knapsack Sprayer Duster

1. Equipment operation should be preceded by gasoline engine oil system checks the operation method and circuit system, and then start to ensure that gasoline is working properly.

2 test with water before adding the liquid hand pump sprayers spray once, check for any leaks everywhere. Do not overfill plus liquid, the liquid must be clean.

3 dusting operation the whole machine should be in powder state. Shut the door and powder pink, powder should be dry and free of debris.

4 Use the process time not too long, should be 3 to 4 people form a group alternate job, you must wear a mask to avoid wind operations, prohibit the operator in front of the nozzle to spray 8-shaped oscillating manner.